【爬架架体】
 |
 |
 |
 |
【Technical Parameters】
| id | Device content | parameter |
| 1 |
Frame height |
Cover no more than 5 times the floor height. |
| 2 |
Main frame height |
According to the height of the floor, it should not be less than 3 times the floor height. |
| 3 |
Frame width |
0.8m≥Frame width≥0.6m。 |
| 4 |
Position (rail) spacing |
Straight line：≤7m；Polyline corner：≤5.4m。 |
| 5 |
Wall support |
At each floor covered by the main frame, a fixed wall support with load bearing, lifting guide, anti-roll and anti-fall function is installed. |
| 6 |
Lifting system |
Independent setting。 |
| 7 |
Lifting equipment |
Electric hoist rated to reset：≥7.5t。 |
| 8 |
Intelligent synchronization control device |
With the programmable microcontroller as the core, set the load signal. When overloaded, the alarm is 15% when the load is underloaded. When overloaded, when the underload is 30%, it stops, and realizes intelligent and automatic control. |
| 9 |
Rated load |
Main construction stage：≤3KN/ m², 2floor ； Main construction stage：≤2KN/ m², 3floor 。 |
| 10 |
Fall arrester |
Gravity pendulum type fall arrester, through the core rod fall arrester, the anti-falling distance is not more than 80mm. |
| 11 |
Anti-rolling device |
Each wall bracket is fitted with an anti-tip device that is slidably coupled to the rail. |
| 12 |
Maximum stroke per lift |
One floor height. |
